5 Steps to Repair The Apple Watch Perfectly
Have you been struggling to fix broken iWatch? Even though you have taken much time to repair it, but the repair effect is still not so good. And you would think that all is a mug’s game. You don’t need to meet this case anymore. We have introduced you how to separate iWatch with iWatch separating mold in the last passage and now we are going to share with you that 5 steps to repair iWatch.
Only five steps can help you to repair one iWatch. It may blow you away. Now let’s see how to do it.
The first step is to remove the broken glass from the screen by using manual separation and steel wire. You should be very careful not to damage the screen during the process, so you had better separate the touch glass carefully and slowly.
The second step is to remove the residual glue on the LCD with manual separation, glue cleanser and a remove glue device. For this step, you have to clean up the LCD after you remove the glue.
The third step is to laminate a new OCA to the new touch glass of iWatch with FORWARD’s universal laminating mold and RMB-2 laminating machine. For this step, we choose OCA laminating mode and set the vacuum time to 40s and the lamination time to 20s while we use the machine to do OCA lamination automatically.
Warm tips: We don’t need to rip off the OCA protective film here so that we can align the position around until we get the right place.
The fourth step is to laminate the affixed touch glass to the LCD with universal laminating mold, a black mat and RMB-2 laminating machine. For this step, we use LCD laminating mode and set the vacuum time to 60s and the lamination time to 30s.
Warm tips: We have to check the screen with bubbles or not after the lamination. If there are some bubbles on it, yet it doesn’t matter, we can put the screen into the bubble removers for defoamming. In general, all the bubbles would vanish after the bubble removing process.
The final step is to assemble the affixed screen to iWatch’s body and test the display and the touch is normal or not after the installation.
That’s all the steps we want to share with you today. For the above steps, we can see that the universal laminating mold and RMB-2 laminating machine are always be used in restoring an iWatch. There is a key point that you should have useful and practical machines and tools to help you complete the crashed screens’ replacement to enable you get twice the result with half the effort.
All right, it is finished today.