How to fix s9 cracked phone without experience?only need 5 steps.

1.Separate the frame of the s9 EDGE


2893980



Open the cover of the freezer, and clean the frost first.put the LCD one the panel of the freezer.


Secondly,set the time to 5 mins, open the machine and start to separate the frame.


2893981


We can use the small knife to open a gap.we can start to separate the frame from the gap with a card.


Firstly,we need to separate one side that without flex cable.secondly,ues the card to separate the side that with cable.


If the LCD not separate immediately,then we need to put it on the panel again.We can use the card to separate it.


2、Separate the glass of the S9 edge


We can separate the glass from the LCD, just 2 mins is ok.


The lcd directly separated.

2893982




Now we start to test.


2893984


touch works well,and dispaly works  well.




2893985




3、remove glue for the s9 edge LCD




2893987

The glus is completely removed.


4、laminate OCA to s9 edge glass and remove bubble


firstly , put the OCA  on the mold and then let it stick to OCA mat.


2893988


put the glass on the mold.


2893989


take out the protector of the OCA.


2893990


and then put the glass mold on the base mold.


2893991

send the base mold into the RMB mahine.




2893992

choose OCA laminate pattern and start to laminate.


2893993


take out the base mold and then the vacuum down to zero..


2893994


and check the glass.


2893995


nearly no have bubble.


2893996


now we remove bubble with machine.


2893997


choose the OCA bubble pattern and set 2 minutes.


2893998


and start the bubble remove inside the machine.


2893999


5、laminate s9 edge LCD and remove bubble


Start to laminate the LCD,put the flex cable mat on the base mold and then we put the LCD on the mold.


2894000


2894015

2894016



And then stick the LCD on the flex cable mat.


2894017


clean the LCD carefully.


2894018


take out the protector of the OCA.


2894019


put the glass mold on the base mold.


2894020


send the base mold into the machine again.


2894021


now we choose the LCD laminate pattern.


2894025


and start to laminate the LCD.

2894026




laminating is finished.


2894024


we take out the base mold and check the LCD.


2894025-1


see,just have a little bubble.


2894026-1


and then remove the bubble.


2894028


set 2 minutes, and now start.


2894029


bubble remove is done, we take out the LCD and test .


2894030


Everything goes well.




2018/08/27 14:19